Single Acting Pneumatic Cylinders with built in Hydro Pneuma

产品概况：

The VB actuator is single acting pneumatic clamp cylinder with built in oleo pneumatic intensifier. Compact in size for large forces up to 2100 daN. With a fully threaded body, for easy adjustment it is simple and quick to install and suited to clamping, holding and riveting applications. Air pressure is applied to the pneumatic piston that causes a plunger to displace the enclosed oil in the hydraulic section of the cylinder. A high pressure stroke results at the hydraulic piston due to the differential areas of the two pistons. A return spring retracts the piston to the rest position when the air pressure is removed. Clamp cylinders must be installed so that the force is directed along the axis and should not be operated without load. They should always be operated in conjunction with a clamping fixture to limit the stroke to within the maximum length specified. It is recommended an effective stroke equal to the maximum minus 1mm.

General Technical Data:
• International standards : N/A
• Bore Sizes : N/A  
• Stroke Length : 3 to 12mm
• Versions : Single Acting Spring Return
• Cushioning : N/A
• Position sensing : N/A
• Installation :
                  - Directly using fully threaded body
                  - With optional mounting block
• Mounting position : Any

Operating and Environmental Data:
• Operating Medium : For best possible service life and trouble-free operation dry, filtered compressed air to ISO 8573-1:2010 quality class 3.4.3 should be used. This specifies a dew point of +3°C for indoor operation (a lower dew point should be selected for minus temperature operation and we recommend the use of an inline dryer) and is in line with the air quality from most standard compressors with a standard filter.
• Operating Pressure : 1 to 9 bar (Except VBH603 and VBH606 1 to 7 bar)
• Operating Temperature : +5°C to +50°C
• Pre-lubricated : Further lubrication is normally not necessary. If additional lubrication is introduced it must be continued.
• Corrosion Resistance : Resistant to corrosion

Material Specification - Cylinder:
• End covers : Zinc plated steel
• Cylinder barrel : Nickel plated steel
• Piston rod : Hardened steel
• Locking rings : Zinc plated steel
• Seals : NBR (Nitrile rubber)


性能特点：

油缸类型		Non-Guided
油缸动作		Single Acting Spring Return
通孔尺寸		N/A
最大冲程（毫米）		12
最大冲程（英寸）		0.47
延长的冲程推力（牛顿）		2400 to 18000 (at 6 bar)
延长的冲程推力（lbs)		-
收回冲程推力(N)		N/A
收回冲程推力(ibs)		-
缓冲类型		-
端口尺寸		G1/8 | G1/4
杆端螺纹类型		N/A
最大工作压力（Bar)		9
最大工作压力（psi)		131
运行环境温度 (C)		+5 to +50
运行环境温度 (C)		+41 to +122
遥感位置		-
装配选择		Yes
证书		-
活塞杆材料		Hardened Steel
阀体材料		Steel
后盖材料		Steel
阀体类型		Round
耐腐蚀的选择		Yes
可修复		Yes